|
|
 |
 |
 |
|
1973 Link Belt 518 (150 ton) S/N
4EW361, 150' boom, Cummins w/Allison Torque.
Price:
$232,500.00 F.O.B.
New Orleans, LA
|
Link
Belt 518 (150 ton) S/N 4EW280, 180 Boom, 30 Jib, GM 8V71
diesel w/Allison Torque, 44 pads, Catwolks, Block &
Ball, cleaned and good paint, Certified.
Price:
$230,000.00 F.O.B.
Dallas, TX
SOLD
|
1980 Link Belt 518 (150 ton) S/N 4EW863, 120' boom, Cummins w/Allison Torque, 3rd drum
Price: $225,000.00 F.O.B.
New Orleans, LA
|
1982 Link Belt 518 (150 ton) S/N 4EW863, 140' boom, Cummins w/Allison Torque, Block.
Price: $295,000.00 F.O.B.
New Orleans, LA
|
Click for
larger image
|
LIMA 2000C
(200 ton) S/N 3577-4, lift, clam, drag, Elevated
Cab, 120 Boom (new), CAT 353 w/3 Stage Torque,
Power Load Lowering on 1 Drum, 80% U/C, Very good
condition.
Price:
$295,000.00 F.O.B.
New
Orleans, LA
|
|
Click for
larger image
|
Manitowoc
4000W (150 ton) Pedestal Crane, S/N 40549, 140'
damaged boom, Cummins w/VICON.Carbody w/o side
frames (tracks) included.
Price:
$75,000.00 F.O.B.
New
Orleans,
LA
SOLD
|
|
Click for
larger image
|
1981 Bucyrus Erie 30B
Super (70 ton) S/N 139970 Crawler crane/clamshell
combination, 70' Angle boom, GM 6-71, fresh
undercarriage, used almost exclusively for lift
work, work ready.
Price: $89,500.00
Delivered anywhere within 300 miles of Jackson, MS
|
|
Click for larger
image
|
1974 American 7260 (100
ton) crawler crane, 120' boom, 3rd drum, Cummins with 3 stage torque,
recent complete refurbishment, like new.
Price: $195,000.00 F.O.B.
VA
|
|
Click for
larger image
|
Amclyde Model 24 Gantry Crane, S/N CW-3886, 80' boom, electric travel. Completely refurbished in the mid 90's then never used and has been stored. At rebuild a new GM 8-71 air start with torque was installed and AmClyde engineered and supervised entire rebuild. New swings, new electronics, new wiring, new controls, new bearings, etc. Over $300,000 spent on rebuild. Started and run quarterly for maintenance while stored. Clam Bucket & all attachments included. Excellent "24".
Price: $395,000.00 New Orleans, LA
|
|
Click for larger
image
|
AmClyde M-35A (200 ton) Revolver Crane, S/N R-1178F.
Boom 200’ w/marine-type boom bumper and a high angle limit switch. Fixed Jib 20’. High side load capability of 4.25 degrees.
Model 380 Independent Boom Hoist driven by 200HP electric motor w/chain & gear drive and double-band brakes.
Main Hoist is a Three Drum Model 450. The three drums are used for Whip, Auxiliary and Main falls. It is chain and gear driven w/6 cyl. Diesel and all three drums are equipped with double-band brakes.
Model 1200C swingers provide 360 swing in either direction at approximately 0.75 rpm.
Two American Model 20-S tuggers controlled from operator’s cab or from the tugger control stand.
Prime mover is a 12 cylinder diesel w/600KW alternator, 480 volt, three phase, 60 Hz when not attached to barge power.
Load Charts, General Arrangement Drawings, and Photographs available upon request.
Operating and Maintenance Manuals
Price: $1,800,000.00 Delivered to The Port of New Orleans as follows:
|
|
|
|
|
 |
Gulf Coast Crane & Marine, LLC
59 Farnham Place, Metairie, LA 70005
Ph: (504) 309-0774 | Fax (504) 309-0040 | Cell (504) 610-5656
Email: gulfcoastcrane@aol.com |
|
Visit
the sites below for more info on New Orleans!
Experience New Orleans! |
New Orleans Restaurants.com
New Orleans Coupon Discounts |
New Orleans Kids
Site designed & maintained by
Compucast Web Design | Copyright© 2003
Please report any problems to the Webmaster
|
|
|
